Basic car roller with 4 stud adaptors, puts the car on its side and lets you work standing upright.
It takes less than fifteen minutes to assemble and turn the car, just raise one side of the car up remove the front and rear wheel, bolt the correct hub plates on the hub slide the holding pins through the frame to the hub plate,lower jack .attach safety bar then its ready to roll.
Also remove the battery and keep the fluids low or drained. Tip it with the petrol neck at the top
A car can be turned by one person using our Basic car roller with 4 stud and an engine hoist or block and tackle.
MAX WEIGHT 2 1/2 TON (2500 KG)
Suitable for use with 4 stud wheels only.

optional extras for cars with 3 stud,5 stud, wide 5 vw porsche and knock ons.

Features

•A car can be turned by one person using an engine hoist or block and tackle.
•You will need approximately 2.5 to 3 metres of space.
If your garage is not wide enough, our Optional Wheel Kit, is the answer.
Fit your car to the frame outdoors, turn the car and then just wheel it back into your garage.
Make sure the battery has been removed and the oil and fluid holes have been blanked off Tip it with the petrol neck at the top
•By using 2 axle stands you can keep the basic roller at 90 degrees
max weight 2 1/2 ton (2500 kg. )
suitable for use with 4 stud only.
optional extras for cars with 3 stud, 5 studs, wide 5 VW Porsche and knock-ons.

Weight 65 kg
Dimensions 170 × 14 × 5 cm

You may also like...

You may be interested in…