Basic car roller with wheel kit ct01g

The CJ Autos Basic car roller with wheel kit puts the car on its side and lets you work standing upright.

It takes less than fifteen minutes to assemble and turn the car. Just raise one side of the car up and remove the front and rear wheels. Then bolt the correct hub plates on the hub and slide the holding pins through the frame to the hub plate. Lower the jack and attach the safety bar. It’s then all ready to roll.
For safety reasons, please also remove the battery and keep the fluids low or drained. Always tip it with the petrol neck at the top.
When using the CT01G, the car can be easily turned by one person using an engine hoist or block and tackle. Please note that you will need approximately 2.5 to 3 metres of space to use this.

MAX WEIGHT 2 1/2 TON (2500 KG. )

The basic car roller with wheel kit will enable you to move your car while on its side. If, for example, your garage is not wide enough to fit your car through the frame. Just turn the car 90 degrees on your drive and then wheel it back into your garage.

There are optional extras available for cars with 3 stud, wide 5 VW Porsche studs and knock ons.

Check out the full range here!